Heinner HFSC-V50LITBK, Руководство пользователя

Страница: 46 / 128

www.heinner.com
45
Oven/Grill (if available) Injectors
The oven and grill injectors are held in position by a single screw on the tip of the
burner.
For oven burners, open the drawer compartment and locate the assembly screw
below the burner. Remove the screw, move the burner diagonally and the injector
will be revealed on the rear side of the burner box.
For grill burners, the screw is already visible. Remove the screw, pull the grill burner
towards you and the injector will be visible on the rear surface of the oven cavity.
Remove the injectors using a 7mm spanner and replace the injector with the ones
from the psare set. Make sure you use corresponding diameters suitable to the type
of gas that is going to be used, according to the information chart (which is also
supplied in the gas conversion kit).
Adjusting the minimum flame position
First of all, make sure that the appliance is unplugged from the mains electrical
supply and that the gas feed is open.
The minimum flame position is adjusted with a flat screw located on the valve. As
shown in the figures below; for valves with a flame failure safety device, the screw is
located on the side of the valve spindle and for valves without a flame failure safety
device, the screw is located inside the valve spindle. To make adjusting the flame
position easier, we recommend that you remove the control panel (and the micro
switch if your model has one) during the alteration. The bypass screw must be
loosened for conversion from LPG to natural gas. For conversion from natural gas to
LPG, the bypass screw must be tightened.