Heinner CH-201SS, Инструкция по эксплуатации

Страница: 22 / 60

www.heinner.com 85W, 50Hz, 220-240V
21
Removing grease mesh filters
a.
Push the grease mesh filter buckles forward and remove the front of the filters.
b. Then push the left or right lower side stops of the filter up until the hanging point
at one side stop is not hanging the hood cavity.
c.
Finally, take the whole mesh filters away.
Please do not use abrasive detergent for it will damage the hood.
INSTALLING GREASE MESH FILTERS
- To install filters for the following four steps.
- Angle the filter into slots at the back of the hood.
- Push the button on handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
CARBON FILTER – buy separately
Activated carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed at three or six months according to your cooking habit. The
installation procedure of activated carbon filter is as below.
1. Remove the grease filter.
2. Place the carbon filter onto the grease filter.
3. Fix the properly-adjusted carbon filter with the small steel wire.
4. Reinstall the grease filter.
5. Use carbon filters for recirculation mode only
NOTE :
Make sure the filter is securely
locked. Otherwise, it would loose
and
cause dangerous. When
activated carbon filter attached, the
suction power will be lowered.