3
PREPARATION
(REFER TO FIGURE 1)
Before Use
1. Verify that the product and application are compatible, if in doubt call
Hein-Werner
technical service.
2. Before use, read the operator's manual completely and familiarize yourself thoroughly with the product, its components
and recognize the potential hazards associated with its use.
3. Insert handle to handle fork. Tighten the bolt on handle fork to prevent accidental removal of handle while in use.
4. To familiarize yourself with the basic operation of these jacks, locate and turn the release valve (handle):
a. Clockwise until firm resistance is felt to further turning. This is the ‘CLOSED’ release valve position used to
raise the load.
b. Counter-clockwise, but no more than 1/2 full turn from the closed position. This is the ‘OPEN’ release valve
position used to lower the load.
5. With saddle fully lowered, locate and remove air vent screw. Pump the operating handle through 6 to 8 full strokes.
Check the oil level. Ensure the oil level is within ~3/16" from the inner cylinder as viewed from the air vent screw
hole.
6. Reinstall the air vent screw.
7. Check to ensure that the jack rolls freely. Raise and lower the unloaded saddle throughout the lift range before
putting into service to ensure the pump and release valve operate smoothly.
8. Replace worn or damaged parts and assemblies with Hein-Werner Replacement Parts only. Lubricate as instructed
in Maintenance Section.
!
WARNING
•
Study, understand, and follow
all printed materials
provided with/on this product before use.
•
Do not
exceed rated capacity.
•
This is a lifting device only!
•
Immediately
after lifting, support the load with
a pair
of appropriately rated jack stands.
• Use only on hard, level surfaces capable of
supporting rated capacity loads.
• Do not use adapters or accessories that are not
provided by the manufacturer.
• Lift only on areas of the vehicle as specified by the
vehicle manufacturer.
• Do not move or dolly loads with this device.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
• Leer, comprender, y seguir las instrucciónes antes
de utilizar el aparato.
• El manual de instrucciónes y la información de
seguridad deben estar comunicado en lengua del
operador antes del uso.
• No seguir estas indicaciónes puede causar daños
personales o materiales.
!
ADVERTENCIA
To avoid
crushing and related injuries
:
•
Never
work on, under or around a load supported
only by hydraulic jack.
•
Always
use adequately rated jack stands.
• Chock each unlifted tire in both directions.
•
Do not
use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
•
Be alert
and
sober
when using this product. Do not
operate under the influence of drugs or alcohol.
!
WARNING
X
