HEIDENHAIN TNC 620, Руководство пользователя

Страница: 357 / 521

MOD functions | Setting up touch probes
9.10 Setting up touch probes
Introduction
Refer to your machine manual.
In the machine parameter
CfgHardware
(no. 100102),
the machine manufacturer decides if the control shows
or hides the touch probes in the
Device configuration
window.
The control allows you to set up and manage multiple touch probes.
Depending on the type of touch probe, you have the following
options for setting it up:
TT tool touch probe with radio transmission: Setup via MOD
function
TT tool touch probe with cable or infrared transmission: Setup via
MOD function or entry in machine parameters
TS 3-D touch probe with radio transmission: Setup via MOD
function
3-D TS touch probe with cable or infrared transmission: Setup via
MOD function, tool management, or touch probe table
Further information: "Touch probe table", Page 148
You can set up touch probes with the
Set up touch probes
MOD
function in the
Machine settings
group.
To open the
Set up touch probes
MOD function, proceed as follows:
Select the
Machine settings
group in the MOD menu
Select the
Set up touch probes
function
The control opens a pop-up window for device configuration on
the third desktop.
9
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
357