HEIDENHAIN TNC 620, Руководство пользователя

Страница: 268 / 521

Testing and running | Test run
6
Using the GOTO key
Jumping with the GOTO key
Use the
GOTO
key to jump to a specific location in the NC program,
regardless of the active operating mode.
Proceed as follows:
Press the
GOTO
key
The control opens a pop-up window.
Enter a number
Select the jump statement by soft key, e.g. move
down the number of lines entered
The control provides the following options:
Soft key Function
Move up the number of lines entered
Move down the number of lines entered
Jump to the block number entered
Use the
GOTO
function only during programming and
testing of NC programs. Use the
Block scan
function
during program run.
Further information: "Any entry into the NC program:
Block scan", Page 283
Quick selection with the GOTO key
With the
GOTO
key, you can open the Smart Select window that
makes it easy for you to select special functions or cycles.
To select special functions:
Press the
SPEC FCT
key
Press the
GOTO
key
The control displays a pop-up window showing a
structural view of the special functions
Select the desired function
Further information: User's Manual for Programming of Machining
Cycles
Opening the selection window with the GOTO key
When the control provides a selection menu, you can use the
GOTO
key to open the selection window. This allows you to view the
available entries.
268
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022