HEIDENHAIN GAGE-CHEK 2000 Series, Руководство по эксплуатации

Страница: 138 / 236

Setup | Single steps for setup
8
Enter values individually
Tap the input field
Enter the desired value
Confirm the entry with
RET
The entered value is applied
Enter values symmetrically
If your desired entry should have identical positive and negative limit values,
you can enter these values by means of
Warning limits , Tolerance limits , and
Minimum/Maximum
input fields.
If you selected to use the absolute value input, then the respective values are
calculated based on the nominal value.
If you selected the
relative
value input, the entered value (positive and negative)
will be transferred directly.
Tap inside the desired input field
Enter the desired value
Confirm the entry with
RET
The entered value is applied
Activate the switching function
Precondition: The output is assigned to the switching function in the settings
Further information: "Switching functions", Page 190
You can assign a switching function to the axes that generates a triggering signal
at the output X113.4 (Dout 0) when a limit you determined is exceeded. This way,
you can further process an exceedance of a limit value as trigger signal.
Tap the desired axis in the
dial gage
dialog
The dialog for entering the values is opened
Swipe right to left over the touchscreen
Activate the switching function with the slide switch for the
axis
Select the desired type of switching
High level on exceeding
Low level on exceeding
Activate Pulse with the slide switch if required
Enter Pulse time if required
Select the desired limit that generates the triggering signal
when exceeded
Warning limits
Tolerance limits
8.3.9 Creating a preset table
You can access the preset table on the status bar. The preset table contains the
absolute positions of the presets with respect to the reference mark. You can save
a maximum of 99 datums in the datum table.
138
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020