HEIDENHAIN 548431-05, Руководство пользователя, Страница: 558 / 722

Tool and technology database | Tool database
8
558
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
8.1 Tool database
You usually program the coordinates for the contour by taking the
dimensions from the drawing. To enable the control to calculate
the slide path, compensate the cutting radius and determine the
proportioning of cuts, you need to enter the tool length, cutting
radius, tool angle, etc.
The control can save up to 250 tool data records (optionally 999);
each tool data record is identified by an ID number (name). The
tool list indicates the maximum number of tool data records and
the number of data records found. For each tool, you can enter an
additional tool description which makes it easier to find the tool
data again when needed.
The
Machine mode of operation has functions for determining the
tool length dimensions.
Further information:
"Tool measurement", Page 132
Wear compensation is managed separately. This allows you to
enter new compensation values at any time, even during program
run.
You can also assign a
cutting material to the tools, which gives
you direct access to the technology database (feed rate, cutting
speed). This saves you a lot of time since you only need to
determine and enter the cutting data once.
Tool types
Tools for drilling, recessing, finishing, etc., have very different
shapes. Therefore, the reference points for determining the tool
length and other tool data also vary.
The following table provides an overview of the tool types.
Tool types
Soft key Function Description
Standard turning tools
Roughing tools
Finishing tools
Page 579
Button tools
Page 579
Recess. tool
Recessing tools
Parting tools
Recess turning tools
Page 580
Threading tool Page 581
NC center drill Page 583
Center drill Page 584
Counterbore Page 585