HEIDENHAIN 548431-05, Руководство пользователя, Страница: 579 / 722

Tool and technology database | Tool data
8
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
579
Standard turning tools
Press the
New tool
soft key
Press the Turning tool soft key
Alternative: For tools with round indexable insert,
switch to dialog for
Button tools
For tool orientations TO =
1, 3, 5 and 7
, you can enter the Setting
angle EW . The tool orientation values TO = 2, 4, 6,8 are used for
neutral tools. Neutral tools are tools that are centered precisely in
the tool tip. One of the setup dimensions for neutral tools refers to
the center of the tool-tip radius.
Special parameters for roughing and finishing tools:
CO
:
Cutting edge position
The main machining direction of the tool influences the
orientation of the tool angle
EW and the point angle SW
(required for
AWG
submode with
TURN PLUS
).
1: Longitudinal preferred
2: Transverse preferred
3: Only longitudinal
4: Only transverse
RS
:
Cutting edge radius
EW : Setting angle (range: 0° <= EW <= 180°)
SW : Point angle (range: 0° <= SW <= 180°)
SUT
:
Tool type
(required for
AWG
submode in
TURN PLUS
)
Further tool parameters:
Further information: "General tool parameters", Page 576
Special parameters for button tools:
RS
:
Cutting edge radius
EW : Setting angle (range: 0° <= EW <= 180°)
DS
:
Special corr.
(for position of the special compensation, see
figure)
Further tool parameters:
Further information: "General tool parameters", Page 576
The wear compensation DX , DZ compensates for wear
on the two sides of the tool tip that lie next to the tool
reference point. The
Special corr. DS compensates for
wear on the third side of the tool tip.