HEIDELBERG e.GO Wallbox home, Руководство по установке

Страница: 17 / 60

● two washers,
● one spring ring,
● one nut.
Note
The fastening materials (screws/dowels)
for mounting the column onto the foun‐
dation are not included in the scope of
supply due to different possible mount‐
ing surfaces.
The fastening screws should have a di‐
ameter of 10 mm. Suitable heavy-duty
dowels or similar for the mounting sur‐
face must be used.
1.5 Assembly of the column
2
1
ST.000.0000-000GRAUND_00
Fig. 1 Fastening of the adapter plate
1. Fasten the adapter plate (Fig. 1/1) to the column
using the four enclosed countersunk screws
M6x16 (Fig. 1/2). Tightening torque 7 Nm.
1.6 Installation of the column if the connecting line exits from the foundation
1. Position the column centrally above the cable
outlet.
1
ST.000.0003-000GRAUND_00
Fig. 2 Base plate of the column
2. Mark the four bore holes on the concrete foun‐
dation using the column's base plate (Fig. 2/1) as
a template.
3. Drill the four mounting holes (diameter according
to the heavy-duty dowels being used).
4. Feed the connecting line into the column from
below.
If the cable is particularly rigid, it is easier to feed
in the connecting line when the column is hori‐
zontal.
If equipotential bonding of the column is required,
a separate equipotential bonding line must be
routed to the column. This also applies to addi‐
tional lines required for an optional external dis‐
Installation instructions
A.1.3