Hegel H90, Руководство пользователя

Страница: 10 / 20

10
On/Off
The H90 amplifier is switched on and off
with the power button, located on the un-
derside of the amplifier, towards the front of
the unit. When powered up, the H90 takes
a few seconds to calibrate. During this time,
the outputs are muted.
NOTE: When powered up, the outputs are
muted and the right hand part of the display
flashes for a few seconds, indicating mute.
This is normal, and is part of the start-up
procedure.
NOTE: When the H90 has been switched off,
wait 30 seconds before powering on again.
Display
The left side of the display shows the se-
lected source input, while the volume value
is shown on the right side of the display. A
flashing volume value indicates the amplifier
is in mute mode.
Headphone Output
Connect the 6.3mm headphone jack to
the front of the H90. This activates the
headphone volume control and mutes the
speaker outputs.
NOTE: Variable Line Output is still active.
Source Selector
The input source selector knob is on the left
side of the front panel.
Volume
The volume control knob is on the right
side of the front panel. The volume level is
indicated by a number between 0 and 99 on
the right side of the display, with 0 being the
mute level and 99 being max volume. The
H90 powers up with a preset volume value.
The volume level is adjusted by turning the
volume knob clockwise or counter clockwise,
or by using the Hegel remote control.
Mute
Pressing the mute button on the Hegel
remote control mutes the outputs on the
amplifier. The volume number flashes to
indicate that mute is on. Press the mute
button, or adjust the volume level, to switch
mute off.
Status Indicators
The Hegel H90 will display the product status
.
If it is connected to a network
If there is a network problem
General Use