_
q
As soon as the
LOAD
sign disappears and disc details are shown on the display, the unit is ready for play.
Push the
4;
(8) button, and play starts with the first track.
_
q
In “play” mode you can go to the track you want to play by using the
9
and
:
(7) buttons, skipping forward
:
and backward
9
.The display moves to higher or lower track numbers accordingly. If you push the
4;
(8)
button after stopping at the track you wish to listen to, play starts at the chosen track. If you change your mind and
do not want to play that track, just push the
p
(6) button, and the unit is restored to its default state.
_
q
You can pause play by pushing the
4;
(8) button, and continue playing by pushing it again. In “pause” mode the
display shows the currently played track number and
P
.
If you do not want carry on listening to the disc, stop playing with the
p
(6) button instead
of keeping the unit in “pause” mode. Never leave the unit in this mode for long!
_
q
You stop playing the disc by pushing the
p
(6) button. After that the display shows the disc details.
_
q
If you push the
:
(7) button while playing, the display shows the current track and changes to the next one almost
immediately and continues playing it from the beginning.
_
q
If you push the
9
button while playing, the display shows the current track and starts playing it again from the
beginning. If the playing of the current track lasts less than 2 seconds, you can skip back one track by pushing the
9
button again. In other words, you need to push the
9
button twice to skip back one track.
The display has two visual states: Constant (lit permanently) and Automatic (dimmed permanently unless operated).
You can switch between these states by pushing the
D
(4) button. By default, after switching on, the display lights up and
remains (Constant).
_
q
In any of its functional states, also when playing, you can switch to the Automatic state. By pushing the
D
(4) button
the display is switched off immediately and only a little pin-point blue LED shows that the unit is switched on.
_
q
While in Automatic state, the display lights up immediately when any of the operational buttons are pushed, although
this does not restore functionality. To restore functionality, you need to push the button again or, alternatively, to hold
down the button longer than for half a second. By doing the latter, not only does the display light up, but also the
relevant function is performed. In Automatic state, the displays dims after 7 seconds, no matter whether the unit
remains idle or starts to play.
When using the “pause” function, during the initial reading in of the disc, and while
skipping between tracks and starting to play a track, the display remains switched on.
_
q
The Automatic state — when the display is dimmed — can be switched back to Constant (continuous lighting) by
pushing the
D
(4) button. The display remains switched on permanently afterwards.
playing the disc
using the display
playing previous / next track
I
I
Note:
Although you can use your Obelisk DT within seconds of switching it on, as with all audio equipment the
best sound quality will be reached after a period of warm-up time, preferably 10-15 minutes. We recommend
keeping the unit switched on continually for optimum performance. However, your Obelisk DT should be
switched off if left unattended for extended periods, or in the event of thunderstorm. As mentioned previously,
it is also necessary to switch the unit off when connecting or disconnecting cables.
(5)
(5).
(5)
(5)
(5)
