CHANGING THE FILTER
N.B.: MAKE SURE THAT YOU USE ORIGINAL DRESTER FILTERS, NR. 8701 (MAIN FILTER), AND NR. 8702 (PRIMARY
FILTER). THESE FILTERS HAVE BEEN TESTED AND APPROVED BY THE PAINT MANUFACTURERS.
The primary filter (item 2 illustration 11) collects most of the coagulated sludge, while the main filter (item 1 illustration 11) collects
the finer paint particles.
Remove the sludge from the primary filter after each coagulation process (once it is completely dry, the sludge is easy to remove
from the filter). By doing so the primary filter can be re-used up to 10 times.
The main filter will gradually become blocked after trapping the finer paint particles. In general, the main filter can be used for up
to 5 coagulation processes. The main filter must however be changed every 1-2 months, otherwise there is a risk that mould will
develop.
N.B.: THE COAGULATION SLUDGE MUST BE HANDLED IN ACCORDANCE WITH REGULATIONS FROM THE
APPROPIATE AUTHORITY. INFORMATION FROM THE PAINT SUPPLIER MAY BE NECESSARY.
SERVICE
Weekly:
Remove the strainer at the bottom of the automatic washer (item 2 illustration 5) and clean it, do not forget to re-fit it !
Monthly:
Remove the five nozzles automatic washer and clean them with clean solvent. (see illustration 8).
When changing drums:
Check and if necessary clean the strainers on the suction hoses.
When changing filters:
Check and if necessary clean the strainer on the suction pipe.
Take out the filtrate container (item 7 illustration 2) and empty it completely. Rinse it with water and wipe it off with
cloth or paper.
Every month:
Change the water completely.
