Q U I C K G U I D E
VOL. [dB]
LINEARISER®
CoP
-6
-12
+12
+6
0
-2
-4
+4
+2
0
LOW
-2
-4
+4
+2
0
HIGH
E
XTEND.
(less SPL)
N
ORMAL
for
S
UB
(80 Hz)
/M
ONO
/L
EFT
A
NALOG
R
IGHT
-4
+4
0
-10
S
MALL
L
ARGE
O
FF
M
ED.
O
N
O
FF
(*)
P
orted
C
losed
SHELVING FILTER [dB]
LF RANGE
ANALOG/AES
INP. SENS. [dB]
DESK FILTER
ALL "0" and "
↑
" POSITION = FACTORY SETTING
ANALOG IN
AES IN
AES THROUGH
1
2
3
5
6
4
7
8
9
10
11
12
1. Volume
/ adjust the output volume
2. HEDD Lineariser®
/ activate or deactivate the HEDD Lineariser® for full phase linearity
3. CoP
/ change the DSP settings according to whether you are using the
speakers ported (without plug) or closed (with plug)
4. Low shelf filter
/ changes bass response in a ± 4 dB range in 1 dB steps to adapt the
speakers to your room
5. High shelf filter
/ changes treble response in a ± 4 dB range in 1 dB steps to adapt the
speakers to your room
6. Low frequency range
/ optionally extend the bass range (at the expense of a lower max. SPL)
or cut off the bass for use as satellite with subwoofers
7. Input selection
/ select your active input or stereo channel / please note that in analog
mode the stereo channel is defined by your pre-amp
8. Input sensitivity
/ adjust the input volume by increasing the input by up to 4 dB
(warning: clipping may occur) or lowering it by up to 10 dB
9. Desk filter
/ correct unwanted reflections of desks and workspaces
10. Analog input
/ use this balanced XLR input connection to connect your HEDD
monitors with an analog balanced output amplifier
11. Digital input
/ use this digital AES connection to connect your HEDD monitors
with a compatible source, for example a corresponding digital interface
12. Digital passthrough
/ use the AES output connection to pass through the input information,
for example to chain multiple speakers
Please download and read the full manual for more information.
1.
Red:
Overload
2.
Green:
Power On
3.
White:
Stand-By
LED INDICATORS