Heaven Fresh NaturoPure HF 280, Инструкция по эксплуатации

Страница: 7 / 24

Heaven Fresh HF 280 7
CLEANINg ANd mAINTENANCE
Make sure unit is unplugged before performing any maintenance!
Disassembling the device
• Open the front cover: Put your hand to the flute part on top of the front cover and pull it out.
• Remove the plasma dust collector and the pre-filter.
• Remove the HEPA filter: hold the handle on two sides of the filter and gently pull it out.
Cleaning the Front Cover
• The front cover can be cleaned with running water. If extremely dirty, use a mild
detergent and rinse with water.
Cleaning the Pre-Filter
Remove the pre filter from the plasma dust collector, and wash with running water. If
extremely dirty, use a mild detergent and rinse with water.
Note: Please wear protective gloves to avoid any cuts on your fingers.
Cleaning the plamsa dust collector
• Use mild detergent to clean
• Use a scouring pad or toothbrush to clean
the dust collector
• Achieve better result with warm water
• If it is hard to eliminate all dirt, presoak
with diluted detergent and then use a
toothbrush to scrub
• Please beware not to damage any wiring
when cleaning the dust collector. In case if any electrical discharge
wire is broken, the device will lose part of or all of its dust collecting
function
• Any broken wire should be thrown away instead of being left
inside the unit. Otherwise, short-circuit or high-voltage spark
would be resulted. Also, the circuit control of the device would be
affected.
• Please contact the distributor for additional electrical discharge wire
• Please do not clean using acidic or alkaline detergent that can create rust on the surface
of device