Heatstore HSRCH3000RF, Инструкция по установке и эксплуатации

Страница: 3 / 9

2
1.1 Introduction
This instruction manual describes the Heatstore
Recessed Warm Air Ceiling Heaters.
The heater is designed for discreet positioning in a
suspended 600mm ceiling within retail or
commercial premises. It can fit a recess as shallow
as 210mm.
1.2 General
All installations must be in accordance with the
regulations in force in the country of use.
These instructions must be handed to the user on
completion of the installation.
Installers and service engineers must be able to
demonstrate competence and be suitably
qualified in accordance with the regulations in
force in the country of use.
To ensure continued and safe operation it is
recommended that the appliance is serviced
annually.
The heater outlet / inlet must not be obstructed
during use.
1.3 Electrical Supply
Electrical supply is 230/240V single phase,
Neutral and Earth. The maximum cable inlet size is
4mm².
It is recommended that the electrical supply to the
base unit in the heater is via an appropriate
switched isolator in accordance with the
regulations in force in the country of use and must
be via a fused isolator having a contact separation
of greater than 3mm on all poles.
BMS control, time switches, room thermostats and
door interlocks can be installed at the discretion
and responsibility of the installer.
All units must be wired in accordance with I.E.E
regulations for the Electrical Equipment of
Buildings and the installer should ensure that a
suitable isolating switch is connected in the mains
supply.
1.4 Controller
RF
The
HSRCH3000RF and HSRCH4500RF
heaters are
supplied without a controller. The
RF
models will not
work without a RF controller. See section 5.1 for
more details.
1.6 Location
All units should be installed horizontally. It is
recommended that the ceiling heater is installed
within the ceiling void or roof space.
Care must be taken to allow complete free air
movement into the inlet grilles of the unit to
ensure the correct working operation of the
heater. If the HSRCH3000RF or HSRCH4500 heaters
are mounted close to the wall or corner the
discharge opening should be facing the wall. The
minimum distance from the wall or corner is 0.8m
.
1.7 Clearance distances
It is recommended that a minimum clearance of
50mm is allowed around the case and 30mm
above the heater. The clearance allows for cable
entry and prevents combustible surfaces
overheating.
The minimum mounting height (floor to grille) is
2.2m for the HSRCH3000RF and the HSRCH4500RF.
The recommended mounting height is 2.5m for
the HSRCH3000RF and HSRCH4500RF.
Heatstore RF Controllers
HSPBRF
HSTIRF
HSVTRF
1 . General Information