OPERATION OF THE HEATER
NOTE:- It is normal when the heater is turned
on for the first time or when turned on after
having not been used for a long period of
time for a smell to be emitted. This will
disappear when the heater has been on a
short while.
INSTALLATION
The appliance requires no installation.
It should be used solely as a portable
appliance. The use of extension leads is not recommended.
Portable appliances are not suitable for use in a bathroom.
OPERATION
Ensure the heater is on a flat, even surface.
Turn the thermostat knob in a clockwise direction until it reaches the
maximum setting.
Summer setting (ventilation only): turn the switch to setting
Heating at mid power: turn the switch to setting
I
(1000W)
Heating at full power: turn the switch to setting
II
(2000W)
Switching off: turn the switch to setting
REGULATING THE THERMOSTAT
When the room has reached the required temperature turn the left
thermostat knob slowly in an anti-clockwise direction up to the point where
the appliance switches off and not beyond. The temperature fixed in this
way will be automatically regulated and kept at a constant level by the
thermostat.
NOTE:- The temperature control does not vary the fan speed.
AUTOMATIC SAFETY CUTOUT
The heater is fitted with a safety device which will switch off the heater in
case of accidental overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all). To reset, disconnect the plug
from the power for approximately10 minutes, remove the cause of
FOR YOUR OWN SAFETY
1. Do not use the appliance in rooms less than 4m
2
area.
2. Only connect the fan heater to a single-phase socket with a main
voltage as specified on the rating plate.
3. Always use in an upright position.
4. Keep the air inlet and outlet free from objects: at least 1m in front and
500mm behind the heater. Keep combustible material such as
furniture, cushions, bedding, paper, clothes, curtains etc. at least 1m
away from the fan heater.
5. Do not hang anything on, or in front of the fan heater.
6. Always unplug the heater when not in use. Do not pull the cord to
unplug the heater.
7. Do not install the heater below a socket.
8. The air outlet gets hot during operation. Do not touch the hot surface.
Unplug the heater and allow to cool for 5 minutes before moving.
9. Do not cover.
10. Do not move the appliance while it is functioning in order to avoid
overheating.
11. Do not use this fan heater in the immediate surroundings of a bath,
shower or a swimming pool.
12. Do not use the fan heater in rooms with explosive gas or while using
inflammable solvents, varnish or glue.
13. Do not use outdoors or leave unattended while in use.
14. Take care when using this appliance near children, the elderly or
infirm.
15. If the power cord is damaged, the appliance malfunctions or is
dropped or damaged, stop using the appliance and contact Heatstore
for further instructions.
16. To avoid overheating, do not cover the cable and ensure it is fully
unwound.
17. Keep the fan heater clean. Do not allow any objects to enter any
ventilation or exhaust opening as this may cause electric shock, fire or
damage to the heater.
18. Store in a cool dry place when not in use.
THERMOSTAT
SWITCH
HANDLE
POWER
INDICATOR
Figure 1
3
2
HS4212XNi[09]_instructions 2/12/08 11:33 Page 3