FIXINGS SUPPLIED
2 x Wall plug
2 x Screw
1 x Hanger
PARTS SUPPLIED
1x
Body drier unit
INSTALLATION
IMPORTANT MOUNTING INSTRUCTIONS
1. When wall mounting the product, always check that there are no water, gas or
electrical cables/pipes within or behind the wall.
2. Ensure the mains supply is switched off before commencing any electrical
installation.
3. The electrical installation should be carried out in accordance with current wiring
regulations and installed by a qualified electrician.
4. Ensure your mains supply rating corresponds with that stated on the rating
label fixed to the Body drier.
5. The Body drier is double insulated and does not require an Earth (ground)
connection.
6. The Body drier must be fixed so that the base unit and the hand held part,
when fully extended, is out of reach of a person taking a bath or shower.
7. Connection of the unit to the electrical supply by fixed wiring should be made
with cable suitable for a 13A loading.
8. When the unit is to be permanently connected to the fixed wiring, a suitable
means for all-pole disconnection (contact separation of at least 3mm) should be
incorporated (e.g. a switched fuse spur fitted with a 13A rated fuse)
WALL MOUNTED
1.
Install The Body Drier with plug connected wire
(Fig. 2)
Note: Use a spirit level to ensure the holder is installed accurately.
1.
Remove the screw located at the bottom of the Terminal cover. Then remove
the cover.
2.
Using an electric drill and a 6mm masonry bit, drill holes at the marked points
according to the dimension show in Fig. 2.
3.
Insert two wall plugs. Then fix the hanger to top hole with the screw.
4.
Align installation body drier to the hanger and screw into the position with the
screw on bottom hole. Then screw in the terminal cover to body drier.
5.
Connect with general power.