Heatrae Sadia Express 50 Litres, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 24

10
6. Installation
6.1 General
After reading the previous sections in this booklet and
choosing a suitable location for the appliance please
install, paying attention to the following water, electrical
and commissioning sections.
Mounting the water heater
The water heater should be mounted using the brackets
supplied following the steps stated below:
�
The top bracket bolts will require mounting to the
appliance. Note the location of the bolt holes used
for the vertical appliances as well as which way up
the appliance should be mounted.
�
The top bracket bolts should be screwed all the
way into the hole until they stop and stick out 8mm
as shown in figure 4 below.
�
The bottom bracket will require mounting to the
casing as shown in figure 5 using the fixings
supplied. This must be done before the appiance
is mounted on the wall
�
Secure the top bracket to the wall using appropriate
fixings. Ensure it is fitted the correct way up.
�
Locate the appliance top bracket bolts in the
corresponding slots in the wall bracket. Ensure
they are fully engaged and seat correctly (figure 4).
�
Secure the bottom bracket to the wall.
Figure 4: Top Bracket
Figure 5: Bottom Bracket
8 ±1.5 mm