12
11
Wireless
Series
Model
: PRT-W
Pairing the Thermostat
Pairing With the UH1-W Wiring Centre
•
On the receiver, press and hold the Pairing button until the Comms LED lights up.
•
With the thermostat turned OFF, press & hold the A button for 5 seconds ...........
•
The thermostat will send a signal for 1 minute and will flash the RF signal icon ...
•
If pairing is successful, the Comms LED on the receiver will flash.
•
Press the Power button on the thermostat once to confirm pairing ........................
If pairing is unsuccessful, check features 06 to 08 have been configured correctly.
To eliminate a possible signal issue, reposition the thermostat closer to the receiver and
repeat the pairing process again.
On the UH1-W wiring centre, take note of the number set on
the rotary switch (Board ID number 1-9).
Each UH1-W on the system needs to have a different ID number.
With the thermostat turned OFF:
•
Press & hold the Clock button until 2 sets of numbers appear on screen ..............
•
The small number 01 in the top right corner of the LCD is the feature number.
•
Press Clock repeatedly until you see feature 06 (Receiver Type) .......................
The options within feature 06 are: 00 = UH1-W or 01 = RC1-W receiver.
•
Use the Up/Down keys to set feature 06 to 00 (UH1-W) ..............................
•
Press Clock again until you see feature 07 (UH1-W Board Address) ................
•
Use the Up/Down keys to set the large digits to the board address
of the UH1-W. This is the number set on the UH1-W rotary switch...
(You must set a unique board address for each UH1-W installed).
•
Press Clock again until you see feature 08 (Zone number, 01-08) ....................
•
The UH1-W is an 8 zone receiver.
Use the Up/Down buttons to select the zone this thermostat
should be linked to ....................................................................................................
•
Press Clock again until you see feature 09 .................................................................
(00 = Underfloor heating, 01 = Radiators.)
•
Use the Up/Down buttons to specify whether the thermostat is
controlling underfloor heating or radiators .....................................................
•
Press A to confirm settings and the display will go blank ....................................
•
Press the Power button once to turn the thermostat back ON .........................
•
Press the Up key to set the target temperature above the room
temperature; the flame symbol will appear and the assigned
zone on the UH1-W will be activated ..........................................................................
This indicates pairing between the thermostat and the UH1-W is successful.
Содержание PRT-W1
Страница 1: ...1 Model PRT W Model PRT W...
