UNVENTED (GAS LOG) ROOM HEATER
INSTALLATION AND OPERATING INSTRUCTIONS
This heater is equipped with a PILOT LIGHT SAFETY SYSTEM designed to turn off the heater
if not enough fresh air is available.
Models HM2-MAN, HM2-T and HM2-MIL-18”, 24” and 33” Burner Units
with HM2-RO and HM2-SO Log Sets
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
WHAT TO DO IF YOU SMELL GAS
+
Do not try to light any appliance.
+
Do not touch any electrical switch; do not use any phone in your building.
+
Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
+
If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency or the gas supplier.
WARNING:
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, personal injury or loss of life. Refer to
this manual for information. Installation and service must be performed by a
qualified installer, service agency or the gas supplier.
16-1010 (04/01)
This is an unvented gas-fired heater. It uses air (oxygen) from the room
in which it is installed. Provisions for adequate combustion and
ventilation air must be provided. Refer to page 5 of these instructions.
This appliance is for supplemental heating only. It should not
be used as a primary heat source for a dwelling.
DO NOT TAMPER WITH PILOT LIGHT SAFETY SYSTEM
WARNING:
If the information in this manual is not followed exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
