Heatilator Eco-Choice WS18-AU, Руководство по установке

Страница: 7 / 16

September 14, 2015 7056-153C
Page 7
WS Series Wood Burner
DESCRIPTION Default Flue Kit Default Flue Kit-
With Flue Shield
A Min. Clearance from back of unit to rear wall 300 100
B Min. clearance from center of spigot to rear wall 468 268
C Min. distance from front of base to fl oor protector front 300 300
D Min. fl oor protector front width 800 800
E Min. distance from rear wall to front of fl oor protector 1291 1091
F Min. distance from unit side to side wall 400 400
G Min. clearance from center of spigot to side wall 730 730
FLOOR PROTECTOR
Heatilator WS22 does not require a insulating Floor Protector, as they are tested and comply with the
minimum Floor Protector requirements of
AS/NZS 2918:2001.
Note:
▪ The minimum Floor Protector sizes are speci fi ed in the clearance chart, see Table 3 & 4.
▪ A Floor Protector can include ceramic tiles with grouted joints fi xed directly onto a wooden fl oor or
a sheet of toughened glass, panel steel or any other non combustible material laid directly onto a
wooden
fl oor.
▪ If installed directly onto a concrete slab, the concrete slab can be considered as the fl oor
protector,but must maintain the minimum measurement listed.
NOTE: HEAT SHIELD REQUIREMENTS FOR HEAT SENSITIVE WALLS
Clearances may be reduced by provision of an appropriately located heat shield refer to
AS/NZS 2198:2001 3.2.3 TABLE 3.1
Table 3
Fig. 7
FLOOR PROTECTOR
D
F
E
G
REAR WALL
SIDE W
ALL
PARALLEL POSITIONING
B
C
A
REAR W
ALL