2
LOG #7:
(SRV446-702)
LOG #6:
(SRV481-705)
LOG #5:
(SRV481-701)
This log sits towards the back on top of the
brackets located on the right and the left. The
two notches on the bottom of the log should
rest over these brackets. For NG units the
back of this log should line up with the back
end of the brackets. For LP units the back of
this log should be recessed a 1/2-inch from
the back of the brackets.
Set log #6 on the top of log #1 and the burner
towards the left by following the flat spot mark
(on log #1). Make sure that the log will clear
the ports on the top of the burner.
Set log #7 on the top of log #2 to the right
(use flat spot). The pointed end should be
towards the center of the burner, and should
rest underneath the pointed end of log #6.
(You should tilt up log #6 while you are doing
that). Make sure that the log will clear the
ports on the top of the burner.
5
6
5
6
7
7
FLAT SPOT
(For use to place log #6)
FLAT SPOT
(For log #7)
FLAT SPOTS
(For log #8)