TIMER - button: setting of the automatic
shut-off time of the fireplace. The settings
range from 0.5 hours to 7.5 hours. The
switch-off time is extended by 30 min.
each time the button is pressed.
•
Press once. The control lamp
lights up. The timer iss et to 0.5
hours.
•
Press again until the desired
setting is set. The control lamp
indicate the setting.
FLAME "-": Makes the flame effect
weaker.
NOTE: The flame effect remains on.
Flame effect must be to be able to
switch on the heating.
•
Press once. Flame effect
becomes weaker.
•
Press again until the desired
setting is reached.
FLAME "+": Makes the flame effect
brighter.
NOTE: The flame effect remains on
Flame effect must be
to be able to switch on the heating.
•
Press once. Flame effect
becomes brighter.
•
Press again until the desired
setting is reached.
HEATER button: Turns the heater on and
off.
NOTE: The heater only works when the
Flame effect is on. If the flame effect is
off, the heater will not turn on.
NOTE: To avoid overheating, use the
heater. It blows cool air for 10 seconds
before it starts to heat.
•
Press once. Indicator lights
up. Fan blows cool air for 10
seconds. Low
Heating level turns on and
blows warm air.
•
Press again. Indicator lights
up. High heat level turns on
and blows hot air.
•
Press again. Heater switches
off
Fan blows cool air briefly
and then turns off.
Temperature limit
This heater is equpped with a temperature limit control. When the heater reaches an unsafe temperature,
the heater automatically turns off.
Reset:
1.
Unplug the power cord from the power outlet.
2.
Set the ON / OFF switch on the CONTROL PANEL to OFF.
3.
Wait 5 minutes.
4.
Check the chimney to make sure that no vents are blocked or clogged. If they are, use a vacuum to
clear the vents.
5.
With the POWER switch turned off, plug the power cord back into the wall outlet.
6.
If the problem persists, have the socket checked by a specialist.
Remote control battery information
This remote control uses two AAA batteries (not included). Battery installation instructions are located on the
battery compartment of the remote control.
Care and maintenance
Cleaning
Metal:
•
Use with a soft cloth, slightly moistened
•
Never use brass polish or household cleaners as they will damage the metal.
Glass:
•
Use glass cleaner and dry carefully with a paper towel or lint-free cloth.
ALWAYS turn off the heater and unplug the power cord before cleaning, changing
light bulbs, or moving the heater. Failure to do so may result in electric shock, fire
or injury.
Never immerse in water or rinse with water. Doing so may result in
electric shock, fire or injury.