-2-
598-1127-03
5. Mount push button. Use either screws or double
sided tape to mount push button.
•
Screw Mounting: To mount with screws, re-
move back of case by pushing in tab on bottom
with a small screwdriver (see Figure 1).
Note:
Remove material in screw holes (if needed)
before mounting with screws. Attach back of
case to door jamb or wall (see Figure 4). Snap
front of push button on.
•
Tape Mounting: When attaching push button
using double sided tape, make sure the surface
of the door jamb or wall is clean.
6. Mount chime. Determine mounting location.
• Drill 7/32" diameter pilot hole for wall anchor.
• Mount keyhole screw to wall leaving about 1/8"
(3 mm) of the screw threads exposed.
• Replace cover onto battery compartment.
• Using keyhole on back of chime base, hang
base on screw (see Figure 5).
Figure 4
A B C 1 2
3
Figure 5
