4
598-1219-04
WIRING LIGHT FIXTURE
Note:
All wiring should be run in accordance with
the National Electrical Code through conduit or
another acceptable means.
Contact a qualified
electrician if there is any question as to the
suitability of the system.
1. To simplify installation, at-
tach one end of S-hanger
to S-hanger terminal (lo-
cated inside canopy) and
the other end to mounting
bracket.
Recommended Grounding Method
1. Loop the fixture ground wire around the fixture
ground screw (located on mounting bracket)
once.
2. Tighten ground screw.
3. Attach end of fixture ground wire to the bare
ground wire inside the junction box using sup-
plied wire nut.
If you are uncertain about the grounding method,
consult your local building code.
ASSEMBLE PENDANT LIGHT
1. Route light fixture wires through mounting rod
(threaded end first) that will connect to the
fixture.
2. Screw rod into light fixture. Tighten mounting
rod securely.
3. Continue this process until desired number of
mounting rods are connected to light fixture
(including the rod connected to the canopy).
IMPORTANT:
TIGHTEN
all connections
securely.
Note:
If necessary, trim away any excess thread
sealant for best appearance.
DUA
L B
RIT
E
®
ON-
TIM
E
TES
T 1
5 10
MIN
OFF
3
6
DU
SK
TO
DAWN
Canopy
Mounting Rod
(Attached to
Canopy)
Light Fixture Wiring
First Mounting Rod
Junction Box
Black to Wire
with Text
Printed On It
Fixture Ground Screw
S-Hanger
S-Hanger
Terminal
S-Hanger
IMPORTANT:
This light fixture is polarized.
Connect the ribbed wire to the house white
wire. Connect the wire with writing on it to the
house black wire.
White to
Ribbed Wire
Fixture Bare
Ground Wire
Bare Ground
Wire
2. Trim light fixture wire length if needed.
3. Connect the junction box wires and the fixture
wires together as shown in the following dia-
gram.
4. Twist and secure wires with wire nuts.
Fixture Bare
Ground Wire
