Pre-Operating Instructions
Pre-Operation #1
Locate Allen Wrench (provided in package) and unscrew (3) three
wheel cover screws.
Pre-Operation #2
Tire pressure should be between 30 - 32 lbs. psi. If tire pressure reads
low, use an air pump to inflate the tire to 30 - 32 lbs. psi. If tire pressure
reads high, decrease the air pressure by pushing down the air stem
bubble located in the middle of the air stem. ••Inspect the air pressure
periodically to make sure air pressure is still within the 30 - 32 lbs. psi
range.••
Check The Air Pressure In The Heater Pitching Machine Tire.
Warning:
Make sure Heater Pitching Machine is unplugged and the
tire is not spinning during these operations.
Pre-Operation #3
Locate Allen Wrench (provided in package) and secure Wheel Cover back
on machine by tightening (3) three Wheel Cover Screws.
Warning - Serious Bodily Injury:
Never operate Heater Pitching
Machine until Wheel Cover is secured on the Heater Pitching Machine
with the (3) three Wheel Cover Screws.
Check Heater Fuse Reset Button
Fuse Re-Set Button
The Heater Pitching Machine has a fuse reset button which is designed
to protect the electronic circuit in the Heater Pitching Machine. If the
Heater will not turn on, check this button to make sure it is not popped
out. If it is popped out, press it back in to reset the fuse circuit breaker.
This should allow the Heater to operate safely again.
Important:
Make sure machine is unplugged and tire is not spinning during the
following operations.
••• Periodically inspect the tire to make sure it is not worn out or punc-
tured. Serious damage could result if operated in this condition •••
