Heatcraft Refrigeration Products LD1C1A, Инструкция по установке и эксплуатации

Страница: 9 / 34

9
Self-Contained Spot Merchandiser
# Installation of Power Cord to Exit the Base-End Panel of the Merchandiser
1
Install the cordgrip into the hole in the base end panel of the merchandiser.
2
Route the power cord through the cordgrip installed in the base end panel and into the control panel through the
hole located in the bottom right hand side of the control panel. Do not tighten the cordgrip until the power cord
wire conductors have been connected into the circuit breaker and terminal board.
3
Connect the color-coded power cord wire conductors into the circuit breaker, terminal board and ground terminal
as shown on the merchandiser wiring diagram.
4
Once the wire conductors have been connected, leave enough slack in the power cord inside the control panel
so that it is not stretched tight.
5
Tighten the cordgrip around the power cord so that the power cord cannot be moved inside the cordgrip.
Installing the Power Cord to Exit the Bottom of the Merchandiser
The steps below and Figure 4-2 illustrate the correct method to field-install the power cord so that it exits at the
bottom of the merchandiser.
# Installation of Power Cord to Exit the Bottom of the Merchandiser
1
Install the cordgrip into the hole in the bottom of the base of the merchandiser inside the control panel.
2
Route the power cord through the cordgrip into the control panel from the underside of the merchandiser base.
Do not tighten the cordgrip until the power cord wire conductors have been connected into the circuit breaker
and terminal board.
3
Connect the color-coded power cord wire conductors into the circuit breaker, terminal block and ground terminal
as shown on the merchandiser wiring diagram.
4
Once the wire conductors have been connected, leave enough slack in the power cord inside the control panel
so that it is not stretched tight.
5
Tighten the cordgrip around the power cord so that the power cord cannot be moved inside the cordgrip.
Figure 4-1. Power cord installation to exit at the base-end panel of merchandiser