heatapp! T2B, Инструкция по эксплуатации, Страница: 39 / 135

Control
S. 39
The set temperature is displayed below the rotary control.
This desired temperature is indicated in the room image using the magic wand. It applies until the timer program end, as a
minimum, however, for the time set in expert mode. If the current room temperature corresponds to the set temperature, the
halo disappears.
The lower limit that can be set for the temperature is defined by the setback temperature specified for the room.
The upper limit that can be set for the temperature is fixed at 28.0 °C.
Note
The temperature set using the rotary control relates to the currently active operation mode of the selected room (comfort
temperature / setback temperature).
If the operation mode is changed by the set cycle time, the temperature set at the rotary control is also reset to the value
specified in the cycle times for the comfort or setback temperature.
However the temperature set at the rotary control applies for at least three hours; resetting by the cycle time takes place
correspondingly later.
10.2.1 Use of Scenes
Scenes allow set cycle times and temperatures to be overridden for the selected runtime of the scenes.
Scenes are allocated to individual rooms (see also section See chapter "
Editing scenes " on page 50).
By tapping the scene symbols you activate scenes for the assigned rooms. At the same time, the input dialogue for the selected
scene opens. Rooms are assigned and the corresponding parameters for the scene are set in this dialogue.
The scene runtime is set via a slide control in hours or days, or for shower scenes the start of the scene is set.
All scenes can be stopped at any time by touching the Stop button.
Note
Activated scenes are highlighted in red-orange.
„Boost“ scene
The "Boost" scene allows quick attainment of a comfort temperature in the assigned rooms. Upon activation the comfort
tempe a fixed temporary increase should heat the room as quickly as possible.
The duration of the function is defined or can be made visible by pressing the symbol again.
The scene runtime can be set in 30 minute steps up to a maximum of 120 minutes.
„Shower“ scene
Under normal circumstances DHW is heated according to the set cycle times.
If outside the set cycle times hot water is required at a certain time, the shower scene can be activated.