Heat & Glo • SUPREME-I30-NZ • 2417-900 Rev. E • 3/18
22
Figure 8.2
CUT AND BEND
FLASHING AS NEEDED
TO FIT CHIMNEY
SEALANT
ADHESIVE
• Trim chimney top plate to minimize excess overhang or
bend over flue tile (see Figure 8.2).
• Place 3/8 in. (10 mm) bead of 300 ºF (149 ºC) silicone
on flue tile top.
WARNING!
Risk of Fire!
Only an approved Hearth &
Home Technologies surround may be used to cover inte-
gral grills on solid fuel burning fireplaces. No other com
-
ponents such as shrouds, sheetmetal plates, etc., may be
used to seal off vents.
WARNING!
Risk of Explosion!
Failure to position the
parts in accordance with these diagrams or failure to use
only parts specifically approved with this appliance could
result in property damage or personal injury.
WARNING!
Risk of Explosion/Combustion Fumes!
Connect vent sections per installation instructions.
• Connect exhaust vent pipe ONLY to exhaust starting
collar and termination cap center collar.
• Connect inlet air vent ONLY to inlet air collar on appliance
and the termination cap inlet air collar.
•
DO NOT
allow vent to sag below connection point to
appliance.
• Remove rear leveling legs from shipping position and
relocate to one of the positions shown in Figure 8.3.
Remove both screws that secure the leveling leg to the
side of the appliance. Turn the leveling leg around so
that the foot is facing out and downward. Line up the
two holes on the leg with the holes on the appliance and
secure with screws. See Figure 8.3.
• Install insert (without surround attached) into existing
fireplace while pulling collar slide plate forward.
• Install gas line into hole provided on side.
• If applicable install remote control wires into insert side
See Section 8.E.
• Secure collar slide plate to appliance by placing locking
handle into position with locking tabs (see Figure 8.1)
and secure with #8 screw.
• Level the appliance from side to side and front to back.
Adjust leveling bolts to desired vertical position so
appliance is level. Use the leveling bolts included with
the manual bag.
• A 1/2 inch gap from the bottom of the appliance to
a metal surface is
RECOMMENDED
for optimal fan
performance. See Figure 5.1.
• Position any excess flexible vent pipe back up into
chimney without sagging. Twist and push flex vent
together to shorten.
• Attach surround. Follow instructions for surround
installation included with the front.
• Push insert into the opening so that it tightly overlaps
the fireplace opening.
D. Placing, Securing and Leveling the
Appliance
