Heat Wagon S405, Руководство по установке и обслуживанию

Страница: 5 / 12

5
INSTALLATION
The Sure Flame S405 is a direct fired gas heater intended to be used primarily for the temporary
heating of buildings under construction, alteration, or repair. Since all the products of combustion
are released into the area being heated, it is imperative that adequate ventilation is provided. The
flow of supply air and combustion gases must not be obstructed in any way. Do not use the heater
with ductwork as this will restrict the flow supply air.
1. Install the heater in a horizontal position and allow the following clearances from any
combustible material or fuel containers:
Front Outlet: 12 feet Sides: 2 feet
Intake: 2 feet Top: 5 feet
Front outlet must not be directed at any LP-Gas container within 20 feet.
Also make sure that no flammable vapors are present in the space where the heaters is being
used.
2. When connecting the heater to a natural gas or propane supply line ensure that the pressure at
the heater inlet is within the specified range. Please refer to Propane and Natural Gas installation
sections on pages 6-7. Excessive pressure (over 1/2” psig) will damage the controls and void the
warranty.
3. Visually inspect the hose assembly and ensure that it is protected from traffic, building materials,
and contact with hot surfaces. If it is evident that there is excessive abrasion or wear, or the hose
is cut, it must be replaced.
4. After installation, check the hose assembly for gas leaks by applying a water and soap solution to
each connection.
5. Connect the heater to an adequate 115 volt electrical supply and in compliance with the
National Electrical Code ANSI/NFPA 7.0. For protection against shock hazard the supply cord
should be plugged directly into a properly grounded three-prong receptacle.
6. In all applications install the heater in such manner that it is not directly exposed to water spray,
rain and/or dripping water.