heat-timer ETV Platinum Plus, Инструкция по установке и эксплуатации

Страница: 11 / 56

059305-00 Rev. D
Heat-Timer Corp.
Installation Instructions
The ETV Platinum Plus installation process consists of the following basic steps:
1. Initial installation (see “Design Considerations” ) on page 11 .
• General piping - unions, isolation valves...
• Locating and installing the sensor(s).
• Piping the optional TMC safety valve. Reference the appropriate TMC safety valve installation manual
for additional instructions
2.
3.
Mounting the Actuator to the mixing valve
4.
Installing the ETV mixing valve(s) (see page 14 )
Mounting the ETV Platinum Plus Module (see page 18 ).
5. Connecting the ETV Platinum Plus wiring (see “Wiring the ETV Platinum Plus” on page
20
).
• Power wiring
• Output wiring
• Input wiring
6. Optionally connecting the ETV Platinum Plus to a communications network (see “Communications
Wiring” on page
27
). Reference the ETV Platinum Plus Remote Communication manual for addition
information.
7. Calibrating the Actuator (refer to page
29
).
8. Completing initial programming of the ETV Platinum Plus (refer to page 36 ).
Required Materials (Not Supplied)
The following materials/tools are required for installation, but are not supplied:
• General hand tools (screwdrivers, wire strippers, power drill, etc.)
• 18 AWG cable (Heat-Timer p/n 703001-01 or equivalent #18/2 cable) – used for ETV Platinum Plus wiring
Design Considerations
When installing the system, certain design considerations must be taken into account. These include:
• General Piping Guidelines (isolation valves, drain cocks, unions, etc...)
• Sensor Probe Locations
• Optional TMC Safety Valve Piping
• Building recirculating loop
• Thermal Trap or proper use of check valves
• Dual/Parallel ETV Valve Piping
See “Piping Diagrams” on page
30
for more information.
• General plumbing tools (wrenches, pipe cutters, etc.)
Installation Instructions 11