4
Leakage Test
Leakage Test
Gas connections on the appliance are leak tested prior to shipment . Possible mishandling
of the appliance during shipment can damage the integrity of some parts .
A complete gas leakage test must be performed again at the installation site . Please
follow the procedure below for leakage test .
1 . It is advised to make a soap / liquid detergent and water solution to identify any
holes/splits or loose fittings in the tube.
2 . Make sure the control tap is in the OFF position on the control panel .
3 . Apply the solution to the hose using a brush or rag .
4 . Turn ON the gas supply and check for bubbles from the hose . If the air bubbles
appear this indicates a leak in the hose .
5 . If a leak is present, turn OFF the gas supply immediately, tighten or replace any
leaking fitting carefully, turn gas again and recheck.
Location
The appliance is for outdoor use only.
Do not use the heater indoors or in an enclosed area. Always ensure that adequate air
ventilation is provided .
• Do not use the heater in a basement or below ground level .
• This appliance should only be used in an above ground open-air situation with natural
ventilation, where gas leakage or combustible materials are dispersed .
• Any enclosure in which the appliance is used should comply with one of the following:
•
Within a partial enclosure that includes an overhead cover and more than two
walls, the following shall apply:
•
At least 25% of the total wall area is completely open and at least 30% of the
remaining wall area is open and unrestricted .
•
If being used on a balcon area, at least 20% of the total wall area should remain
open and unrestricted .
This appliance should only be used in an outdoor area and shuld not be used in a
building, garage or any other enclosed area.
