Heat Converter swimming pool heat pump, Руководство пользователя

Страница: 5 / 8

Note:
Please make sure the water pump is running in circulation with adequate rate of
water flow.
Startup Procedure
after Installation is completed, and please follow these steps:
(1) Turn on your filter pump ,check water leaks and verify flow of swimming pool
(2) Turn on the electrical power supply to the unit, then press the key ON/OFF of wire
controller, it should start in several seconds.
(3) After running a few minutes make sure the air ventilation from the side (top) of the
unit is cooler ( Between 5
℃
and 10
℃
)
(4) When turn off the filter pump, the unit should also turn off automatically, if not, then
adjust the flow switch
(5) Allow the unit and pool pump to run 24 hours per day until the water reaches the
desired temperature. When thetemperature reaches the setting value, the HP unit
will shut down, when the pool temperature drops more than 1
℃
, please restart (as
long as HP unit is running )
Water Flow Switch:
It is equipped with a flow switch for protecting the HP unit running with adequate water
flow rate .It will turn on when the pool pump runs and shut it off when the pump shuts off.
If
the pool water level higher than 1 m above or below the heat pump's automatic
adjustment knob, your dealer may need to adjust its initial startup.
Time Delay:
HP unit should be equipped with a 3-minute built-in solid-state re-start delay protection
.
Time delay control is an integral part of the circuit control, it can eliminate restart
cycling and contactor chatter.
The time delay will automatically restart the HP unit approximately 3 minutes after each
control circuit interruption. Even a brief power interruption will activate the solid state 3
minute restart delay and prevent the unit from the starting until the 3 minutes countdown
is completed.
4. Initial Startup of the unit
1
0
HE AT
LED display
Press to
adjust the water
temperature
Press to set Timer on
Press to set Timer off
Press to set the Time
Press to turn
on and turn off the Unit
Operation mode
instruction
5. Operation Heating Only
5.1 The functions of LED wire controller
(1) Long press " " 5 seconds to enter operating parameter setting interface
.
(2) Under parameter setting, Press and hold for 5 seconds to enter operating
parameter setting interface
(3) Under parameter setting, Press " "again to start setting parameters from 0 to
A#, (see operation parameter table)
.
(4) Leave it 8 seconds, LED will display water in temperature (under running) or time
(until stops)
.
(5) Under current mode, press or to modify the water setting temperature
whenever it is ON/OFF status.
5
.
2 How to set operation parameter ( LED display show real time till HP
unit is power off. )
06
... ...
07