Heat Controller EKTC07-1G, Руководство пользователя, Страница: 11 / 18

Heat Controller, Inc.
OwnEr’s Manual
Packaged Terminal A/C
10
SYSTEM CONFIGURATION
VEnTIlaTIOn COnTrOl
The ventilation control lever is located at left side of unit,
behind front panel.
nOTE : The vent door shipping hardware must be removed
before using vent control lever. See Installation Instructions.
When set at ClOsE , only the air inside the room is circulated
and filtered.
When set at OPEn , some outdoor air will be drawn into room.
This will reduce heating or cooling efficiency.
Energy Tip :Keep the vent control at ClOsE . Room air will
be filtered and circulated.
aDJusTInG aIr DIrECTIOn
To adjust air direction from outward (default) to upward:
1. Remove front panel. See Fig. 7.
2. Remove louver screws that hold louver insert in place (from back side of front panel). See Fig. 13.
3. Turn louver insert and rotate 180°. See Fig. 14.
4. Replace louver insert.
5. Replace screws and front panel.
Fig. 12—Ventilaiton Control Location
Fig. 13—Backside of Front Panel
Fig. 14—Adjusting Louvers
Open
Close
Vent Control
(Pull lever through label
to operate.)
Louver screws
Louver screws
Air discharge upward
Air discharge outward (Default)