background image

4

Heat & Glo  •  GLASS-5/7/9, GLASS-3X/5X/7X/9X Installation Instructions  •  2372-951 Rev. F  •  11/18

Please contact your Heat & Glo dealer with any 

questions or concerns. 

For the location of your nearest Heat & Glo dealer, 

please visit www.heatnglo.com.

Heat & Glo, a brand of Hearth & Home Technologies  

7571 215th Street West, Lakeville, MN 55044

www.heatnglo.com

 

SL-X Series Only 

(Not Installed on 350X-AU or 550X-AU)

 

Install the top refractory by holding the part horizon-

tally as shown in Figure 11.  Insert the top panel into 

the space between the firebox top and the top edges 

of the side refractory panels as shown in Figure 12.  

The refractory panel should rest on all sides of the 

glass as shown in Figure 12.

Note: 

 The refractory top panel is designed to fit tightly.  

It may be helpful to insert the top at a slight angle when 

installing as shown in Figure 11.

  

13. Reinstall logs, glass assembly, and decorative front.

Figure 11.  Install Top Refractory Panel

Figure 12.  Top Refractory Panel 

TOP REFRACTORY 

PANEL INSTALLED

Содержание GLASS-5

Страница 1: ...ry bracket in place See Figure 2 Retain these screws for later use SL 5 SL 7 SL 9 350X AU 550X AU Remove the two screws adjacent to the air passage as shown in Figure 2 CAUTION Risk of Cuts or Abrasions Wear protective gloves and safety glasses during installation NOTICE Handle refractory panels with care Refractory may chip or crack if dropped or impacted GLASS 5 GLASS 7 GLASS 9 GLASS 3X GLASS 5X...

Страница 2: ... and discard the two screws located below the rear exhaust hole See Figure 5 Install the sleeve onto each 1 1 4 inch 32 mm screw and install in holes See Figure 6 350X AU 550X AU These screws attach the upper heat shield to the back of the firebox Replace these screws with the 1 1 4 inch 32 mm screws and sleeves without removing the heat shield Figure 5 Remove Screws Figure 6 Install Sleeves REMOV...

Страница 3: ...own 10 Install the rear glass panel by placing the lower edge into the rear lower glass bracket Ensure the smooth side is facing toward the front of the fireplace Tip glass back until the glass touches the screw head previously installed in step 7 Keep one hand on the rear glass panel and proceed to step 11 11 With one hand on the rear glass panel bend up one hand bend tab on the upper glass brack...

Страница 4: ...stall the top refractory by holding the part horizon tally as shown in Figure 11 Insert the top panel into the space between the firebox top and the top edges of the side refractory panels as shown in Figure 12 The refractory panel should rest on all sides of the glass as shown in Figure 12 Note The refractory top panel is designed to fit tightly It may be helpful to insert the top at a slight ang...

Отзывы: