Heat & Glo Lifestyle Collection • GFK-160T Instructions • 2087-023 Rev. E • 6/10
3
4.3 INSTALLING THE SPEED CONTROL
AND SENSOR SWITCH
1. Remove the knob and locknut from the variable speed
control. Slide the control behind valve bracket in the
front of fi replace, with the stem sticking out of the pre-
punched hole. Attach the locknut tightly and reattach
the knob on the stem.
2. Secure wires to sensor switch bracket.
3. Slide the temperature sensor switch/bracket assembly
onto the fi rebox inner top of fi replace. Secure the bracket
assembly with supplied screw, see Figure 3.
NOTE:
The switch/bracket assembly
must
be installed
so that the sensor switch is towards the top of the unit.
4. Connect the variable speed control and the temperature
sensor switch to the junction box with the wires provided.
For the wiring diagram see Figure 4.
5. Turn the 110-120 VAC service "ON" at the circuit breaker
and turn the speed control switch to the "ON" position.
FIGURE 4 Fan Wiring Diagram
NOTE:
IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THE APPLIANCE
MUST BE REPLACED, IT MUST BE REPLACED WITH TYPE 105
O
C RATED WIRE.
SPEED
CONTROL
BLOWER
JUNCTION BOX
TEMPERATURE
SENSOR
SWITCH
WIRE LEAD
WIRE LEAD
CORD ASSEMBLY
GROMMET
GLASS
RETAINER
WING NUT (2)
HOOD
SCREW
TEMPERATURE
SENSOR SWITCH
FIGURE 3
