2
Figure 3
Figure 2
Figure 5
Figure 4
11.
Using a metal washer and slotted hinge screw, attach
bottom pivot bracket onto the bottom of each door where
the set screw was removed. (Bottom of door is defined
by holes in part for door handle.)
12.
Screw handle onto each door.
13.
Place nylon washer over hole in the bottom face of fire-
place.
14.
Pick door up and insert bottom pivot bracket in the hole
making sure you engage the nylon washer. HOLD ONTO
THE DOOR UNTIL NEXT STEP IS COMPLETE.
CLEAN NEW MASONRY
Mortar and masonry cleaning agents will corrode metal un-
less they are neutralized. Therefore, if your fireplace sur-
round has been faced with any type of masonry, wash it
with ammonia water or a baking soda solution so the metal
trim pieces of your kit will not be corroded.
NOTE: THE
METAL ON THE GLASS DOORS SHOULD
BE CLEANED WITH A MILD SOAP AND WATER ONLY.
INSTALLATION INSTRUCTIONS
1.
Unscrew, remove and discard top door track.
2.
Remove mesh rod and mesh.
3.
Unscrew, remove and discard hearth filler (part covering
the front of the hearthstone) by lifting and twisting one
end at a time out from behind the columns.
4.
Lift up front of the hearthstone. While pulling stone for-
ward, hold it up and slip FRONT FILLER under the stone
making sure the ears fit in behind the sides of the unit.
Push and sit the stone back into the unit (See Figure 2).
5.
Slip side fillers in on both sides so long flange is behind
columns (see Figure 3).
TOP
TRACK
SIDE
FILLER
BOTTOM
TRACK
TOP CORNER
BRACKET
BOTTOM CORNER
BRACKET
HOLES FOR
DOOR HANDLE
6.
Screw top and bottom track to unit.
7.
Push side fillers up tight against door tracks and secure
with screws through holes in back of top and bottom
tracks (see Figure 4 for part orientation).
8.
Remove shipping tape from doors.
9.
Turn doors face down (gasket side up).
10.
Remove one set screw from top of top corner bracket
and one from bottom of bottom corner bracket (see
Figure 5). Discard the removed set scews.
