39
Is the water temperature too low? For best dishwashing results,
water should be 120°F (49°C) as it enters the dishwasher.
Did you use the correct amount of e ective detergent? Use
recommended dishwasher detergents only. Do not use less
than 1 tbs (15 g) per load. Detergent must be fresh to be
e ective. Heavy soil and/or hard water generally require extra
detergent.
Using dishwasher detergent tablets and packs have been
proven better than powder, liquid or gel detergents to reduce
lming on your dishes. By using these tablets and packs, over
time this will start to reduce or eliminate white lm. Also, by
using a rinse aid you can minimize repeat buildup of white lm.
Is the home water pressure high enough for proper dishwasher
lling? Home water pressure should be 20 to 120 psi (138 to
828 kPa) for proper dishwasher l. If you have questions about
your water pressure, call a licensed, qual
plumber.
NOTE:
To remove spots and m from glassware, remove all
silverware and metal items and run a vinegar rinse as described
in “Dishwasher Care.”
Silica lm or etching (silica lm is a milky, rainbow-colored
deposit; etching is a cloudy lm)
Sometimes there is a water/chemical reaction with certain
types of glassware. This is usually caused by some
combination of soft or softened water, alkaline washing
solutions, insu cient rinsing, overloading the dishwasher, and
the heat of drying. It might not be possible to avoid the
problem, except by hand washing.
To slow this process use a minimum amount of detergent but
not less than 1 tbs (15 g) per load. Use a liquid rinse aid and
underload the dishwasher to allow thorough rinsing. Silica lm
and etching are permanent and cannot be removed. Do not use
heated drying.
White spots on cookware with nonstick nish
Has the dishwasher detergent removed cookware seasoning?
Reseason cookware after washing it in the dishwasher.
Brown stains on dishes and dishwasher interior
Does your water have high iron content? Rewash dishes using
1-3 tsp (5-15 mL) of citric acid crystals added to the covered
section of the detergent dispenser. Do not use detergent.
Follow with a Normal wash cycle with detergent. If treatment is
needed more often than every other month, the installation of
an iron removal unit is suggested.
Black or gray marks on dishes
Are aluminum items rubbing dishes during washing?
Disposable aluminum items can break down in the dishwasher
and cause marking. Hand wash these items. Remove
aluminum markings by using a mild abrasive cleaner.
Orange stains on plastic dishes or dishwasher interior
Are large amounts of tomato-based foods on dishes placed in
the dishwasher? It may be necessary to use a stain removal
product to remove stains from your dishwasher. Stains will not
a ect dishwasher performance.
Noises
Surging sounds
Surging sounds can occur periodically throughout the cycle
while the dishwasher is draining
Valve hissing
Normal water valve hissing may be heard periodically, during
the water ll.
Snapping sound
A normal snap sound may be heard when the detergent
dispenser opens during the cycle, and when the door is
opened at the end of the cycle.
Grinding, grating, crunching or buzzing sounds
A hard object has entered the wash module (on some models).
When the object is ground up, the sound should stop. If the
noise persists after a complete cycle, call for service.
Dishwasher stops and starts
Numerous starts and stops
It is normal to hear numerous starts and stops during
throughout your entire cycle. These starts and stops are
needed to provide optimal cleaning performance and energy
savings.
Depending on cycle selected
Depending on the cycle selected and the soil level sensed by
the “Optical Water Sensor” (in some models), you will
experience more starts and stops throughout the entire cycle.
Dishes are not completely clean
Food soil left on the dishes
Is the dishwasher loaded correctly?
Check and clean your lters regularly. See the table in
“Filtration System” section for “Recommended Time Interval to
Clean Your Filter.”
Did you choose the cycle that describes the most di cult soil in
your dishwasher? If you have some items with heavier soils,
use a heavier cycle.
Is the water temperature too low? For best dishwashing results,
water should be 120°F (49°C) as it enters the dishwasher.
Did you use the correct amount of fresh detergent? Use
recommended dishwasher detergents only. Do not use less
than 1 tbs (15 g) per load. Detergent must be fresh to be
e ective. Heavy soil and/or hard water generally require extra
detergent.
Is detergent caked in dispenser? Use fresh detergent only. Do
not allow detergent to sit for several hours in a wet dispenser.
Clean dispenser when caked detergent is present.
Is the pump or spray arm clogged by labels from bottles and
cans?
Is the home water pressure high enough for proper dishwasher
lling? Home water pressure should be 20 to 120 psi (138 to
828 kPa) for proper dishwasher ll. If you have questions about
your water pressure, call a licensed, quali ed plumber.
Are high suds slowing the wash arm? Do not use soap or
laundry detergents. Use recommended dishwasher detergents
only.
Dishes are damaged during a cycle
Chipping of dishes
Did you load the dishwasher properly? Load the dishes and
glasses so they are stable and do not strike together from
washing action. Minimize chipping by moving the rack in and
out slowly.
NOTE:
Antiques, feather-edged crystal, and similar types of
china and glassware might be too delicate for automatic
dishwashing. Wash by hand.