HearthStove Manchester 8330, Руководство пользователя

Страница: 38 / 43

Hearthstone Quality Home Heating Products, Inc. Manchester Model 8330 Pellet Stove
Page 38 of 43
Display Problem Possible Causes Solution
Flame
Sensor –
(code F06) Temp sensor in
firebox is
malfunctioning Flame sensor not working Reset the unit using the power switch
and contact your dealer if the problem
persists.
Room
Sensor –
(code F07) Communication
between room sensor
and stove interrupted Room sensor unplugged Check the rear room sensor connection
at the rear of the stove or the
connection on the inside of the room
sensor.
Sensor malfunction Replace room sensor.
Too Little
Air – (code
F09) Not enough air flow
through firebox
(monitored by
sensors in inlet pipe) The front door or ash pan
open Check both and verify that they are
closed completely
Inlet or exhaust venting
blocked. Inspect all venting. Verify there is no
blockage. Clean Venting
Excessive interior negative
pressure Install outside air inlet.
Door gasket worn or
missing Check gasket using the dollar bill test
outlined in this manual (see page 34).
Replace gasket if necessary
Exhaust blower clogged Clean the blower. Follow the procedure
in the Maintenance section of this
manual.
Dirty stove Preform a Yearly Cleaning (see page
33)
Poor air flow, or exhaust
fan speed too slow Replace 3” exhaust venting with 4”
If everything checks, out and problem
persists – increase exhaust fan speed
Cap Open Hopper sensor not
engaged.
Note: The cap open error
causes the auger to stop
and will starve the stove for
fuel if not addressed
quickly.
Hopper open Close hopper door
Pellets on gasket seal Clean off seal
Hopper overfilled Remove some pellets
Hopper door not sitting
correctly on hinges. Check that the slots on the hopper door
are fully engaged and the set screws
are tight
Sensor magnet dislodged. Remount magnet on bottom of hopper
door.
Sensor malfunction Replace sensor
Flue Gas
Fan Faulty
– (code
F05) The signal has
stopped from the
exhaust blower Exhaust blower not working Service the unit.
Exhaust blower sensor wire
disconnected Service the unit.
Exhaust blower clogged Clean the exhaust blower. Follow
procedure Maintenance section of this
manual. Blades must move freely.