HearthRite HB20MN-1, Руководство владельца по эксплуатации и установке

Страница: 8 / 24

8
INSTALLATION
Figure 11 - Mounting Heater Onto
Mounting Bracket
Figure 9 - Folding Anchor
Figure 10 - Popping Open Anchor
Wing For Thin Walls
Attaching Mounting Bracket to
Wall
Note: Wall anchors, mounting
screws, and spacers are in
hardware package. The
hardware package is provided
with heater.
Attaching To Wal l Stud Method
For attaching mounting bracket
to wall studs
1. Drill holes at marked locations
using 9/64
"
drill bit.
2. Place mounting bracket onto
wall. Line up last hole on each
end of bracket with holes drilled
in wall.
3. Insert mounting screws through
bracket and into wall studs.
4. Tighten screws until mounting
bracket is firmly fastened to
wall studs.
Attaching To Wall Anchor Method
For attaching mounting bracket to
hollow walls (wall areas between
studs) or solid walls (concrete or
masonry)
1. Drill holes at marked locations
using 5/16
"
drill bit. For solid
walls (concrete or masonry),
drill at least 1
"
deep.
2. Fold wall anchor as shown in
Figure 9 below.
3. Insert wall anchor (wings
first) into hole. Tap anchor
flush to wall.
4. For thin walls (1/2
"
or less),
insert red key into wall
anchor. Push red key to
"
pop
"
open anchor wings.
(see Figure 10).
IMPORTANT: Do not
hammer key! For thick walls
(over 1/2
"
thick) or solid walls,
do not pop open wings.
5. Place mounting bracket onto
wall. Line up last hole on
each end of bracket with wall
anchors.
6. Insert mounting screws through
bracket and into wall anchors.
7. Tighten screws until mounting
bracket is firmly fastened to
wall.
Placing Heater On Mounting
Bracket
1. Locate two horizontal slots on
back panel of heater (see
Figure 11).
2. Place heater onto mounting
bracket. Slide horizontal slots
onto stand-out tabs on
mounting bracket.
Installing Bottom Mounting
Screws
1. Locate two bottom mounting
holes. These holes are near
bottom on back panel of
heater(see Figure 12).
2. Mark screw locations on
wall.
3. Remove heater from mounting
bracket.
4. If installing bottom mounting
screws into hollow or solid wall,
install wall anchors. Follow steps
1 through 4 under
Attaching To
Wall Anchor Method
. If installing
bottom mounting screw into
wall stud, drill holes at marked
locations using 9/64
"
drill bit.
5. Replace heater onto mounting
bracket.
6. Place spacers between
bottom mounting holes and
wall anchor or drilled holes.
7. Hold spacer in place with one
hand. With other hand, insert
mounting screw through
bottom mounting hole and
spacer. Place tip of screw in
opening of wall anchor
or drilled holes.
8. Tighten both screws until heater
i s f i r m l y s e c u r e d t o
wall. Do not over tighten.
Note: Do not replace front panel
at this time. Replace front
panel after making gas
connections and checking for
leaks (see pages 8 and 9).
Figure 12 - Installing Bottom
Mounting Screws