30344 Rev C
12
02-02
NOVI30 AND NOVI35
7. Optional Grille Brass Trim.
To place the brass trim on the upper grille and control access panel, place the angled
side of the brass trim onto the louver first. From the center of the trim piece, press the bottom edge of the trim onto
the louver, moving out to each end. See Figures 19 and 20.
Note:
The brass trim is only to be located on the lower louver of the top grille and on the
top louver of the control access panel. See Figure 21.
Figure 19
Putting Trim on Upper Grille
Figure 20
Putting Trim on Control Access
Panel
Figure 21
Brass Grille Trim Assembled
J. APPLIANCE PREPARATION
The logs are shipped in place. If you have any questions regarding the logs, please contact your local dealer or the
Heatilator Technical Services Department.
1. PLACING THE LAVA ROCK AND VERMICULITE
Figure 22 shows the proper way to disperse the lava rock. It is not necessary to use the entire bag of lava rock
.
Lightly sprinkle vermiculite on top of the lava rock to complete the ash bed. See Figure 23.
2. PLACING THE ROCK WOOL
a.
Tear the rock wool into pieces no larger than 1/2 diameter.
b.
Lay the rock wool pieces on the top of the burner so that the flame can touch the rock wool and create the look
of glowing embers.
c.
Be sure not to pack the rock wool against the gas ports of the burner. As with the lava rock, it is not necessary
to use the entire bag of rock wool. See Figure 24.
Note:
Placement of the rock wool and lava rock should be done with care and time, as
this will effect the look of the fire when burning.
Figure 22
Placing the Lava Rock
Figure 23
Placing the Vermiculite
Figure 24
Placing the Rock Wool
All manuals and user guides at all-guides.com
