www.usaprocom.com
200067-01A
18
INSTALLATION
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation
and periodically thereafter,
check to ensure that no yellow
flame comes in contact with any
log. With the heater set to High,
check to see if yellow flames
contact any log. If so, reposi-
tion logs according to the log
installation instructions in this
manual. Yellow flames contact-
ing logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs. Use only
logs supplied with heater.
Each log is marked with a number. This
number will help you to identify the logs when
installing.
After installing logs, add decorative cinders
around the grate base, do not place any
decorative cinders on logs or burner.
1. Insert log #1 into slots in rear log bracket
on grate base and tighten nuts.
2. Insert log #2 on the pin to the left of the
burner.
3. Insert log #3 on the pin to the right of the
burner.
4. Insert the pin on the bottom of log #4 into
recessed hole in log #1, with the other end
placed on log #2.
5. Insert the pin on the bottom of log #5 into
recessed hole in log #1, with the other end
placed on log #3.
Figure 19 - Installing Logs #1, #2 and #3
Figure 20 - Installing Log #4, #5 and #6
Figure 21 - Installing Log #7 and #8
6. Insert the pin on the bottom of log #6 into
recessed hole in log #1, with the other end
placed on log #2.
7. Insert the recessed hole on the bottom
of log #7 onto pin on the log #6, with the
other end placed on log #3.
8. Place logs #8 on the floor in front of the
burner.
