background image

Hearth & Home Technologies  •  RC100 Wireless Wall Switch  •  2166-391 Rev. C  •  9/10

1

Installation & Operating Instructions

RC100

IntelliFire Plus™ Wireless Wall Switch 

Hearth & Home Technologies disclaims any responsibility for, 
and the warranty will be voided by, the following actions:

•  Installation and use of any damaged system component.

• Modifi cation of the system component.

•  Installation other than as instructed by Hearth & Home 

Technologies.

•  Installation and/or use of any component part not approved 

by Hearth & Home Technologies.

Any such action may cause a fi re hazard.

•  Read, understand and follow these instructions for safe 

installation and operation.

Introduction

The RC100 wireless wall switch is designed to turn 
your gas fi replace on and off. The RC100 wireless wall 
switch is only for use with the Hearth & Home Tech-
nologies IntelliFire Plus™ system (IPI).

FCC Requirements

WARNING! Risk of Fire! Changes or modifi cations  to 
this unit not expressly approved by the party responsible 
for compliance could void the user’s authority to operate 
the equipment.

Note: 

This equipment has been tested and found to 

comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against 
harmful interference in a residential installation. This 
equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful in-
terference to radio communications. However, there is 
no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful 
interference to radio or television reception, which can 
be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by 
one or more of the following measures:

•  Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment and 

receiver.

•  Connect the equipment into an outlet on a circuit dif-

ferent from that to which the receiver is connected.

•  Contact the dealer or an experienced radio TV techni-

cian for help.

Canadian Equipment Requirements

This digital apparatus does not exceed the (Class A/ Class 
B) limits for radio noise emissions from digital apparatus 
set out in the Radio Interference Regulations of the Cana-
dian Department of Communications. Le present appareil 
numerique n’emet pas de bruits radioelectriques depas-
sant les limites applicables aux appareils numeriques (de 
la class A/de la class B) prescrites dans le Reglement sur 
le brouillage radioelectrique edicte par le ministere des 
Communications du Canada.

This device complies with RSS-210 of Industry and Science 
Canada. Operation is subject to the following two condi-
tions: (1) this device may not cause interference, and (2) 
this device must accept any interference, including interfer-
ence that may cause undesired operation of the device.

Wall Switch Location Requirements (For Ap-
pliances Installed Outside The United States 
And Canada)

This wireless wall switch must be installed a minimum of 
44 inches (112 cm) above the fl oor. This measurement is 
taken from the from the center of the wall switch.

Installation Precautions

This wall switch is tested and safe when installed in ac-
cordance with this installation manual. Do not install any 
components that may be damaged. 

Do not modify, disassemble, or substitute any of the com-
ponents included with this kit. Installation of this unit must 
be done by a qualifi ed service technician.

Placement of this wall switch may affect performance. An 
assessment of the space should be done prior to installa-
tion for optimum performance.

Determine Location

Determine the location for the wireless wall switch. The 
selected location should be in the same space as the gas 
fi replace with visual sight of fi replace. The wireless wall 
switch must be placed within 30 feet (9.14 m) of the fi re-
place but should not be exposed to extreme heat.

The RC100 is approved for interior installation and should 
always be placed under weather resistant cover when used 
in exterior applications.

f i r e - p a r t s . c o m

Отзывы: