Hearth and Home Technologies HEAT-OUT-GAS, Руководство по установке

Страница: 1 / 14

1
Hearth & Home Technologies • HEAT-OUT-GAS Instructions • 2310-939 • 3/17
HEAT-OUT-GAS
- Installation Instructions -
1 1
Introduction
DO NOT DISCARD THIS MANUAL
NOTICE
• Leave this manual with
party responsible for use
and operation.
DO NO
T
DISCARD
• Important operating
and maintenance
instructions included.
• Read, understand and follow
these instructions for safe
installation and operation.
Table of Contents
1 Introduction
A. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
B. Approvals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
C. Kit Contents of HEAT-OUT-GAS . . . . . . . . . . . . . . . . . . . . 2
D. Installation Guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
2 Framing
A. Framing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
B. Installing Vent Cap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
C. Connecting Insulated Flex Duct . . . . . . . . . . . . . . . . . . . . 12
3 Electrical Information
A. Wiring the Appliance for the HEAT-OUT-GAS . . . . . . . . . 13
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
Installation of the HEAT-OUT-GAS may be done by a
quali
fi ed service technician only. Installation MUST com-
ply with local, regional, state and national codes and reg-
ulations.
IMPORTANT:
Failure to read and follow these instruc-
tions may create a possible hazard and will void the fi re-
place warranty.
These instructions must remain with the equipment.
CAUTION! Failure to install, operate, and maintain the
power venting system in accordance with manufacturer's
instructions will result in conditions which may produce
bodily injury and/or property damage.
NOTICE: The blower motors present in the HEAT-OUT-
GAS Power fl ow Heat Management System will gener-
ate sound during operation. The effects of the increased
sound level can be minimized with careful planning during
installation of the system.
C AUTION! Risk of Shock! Disconnect electrical power
from fi replace/power vent before performing any mainte-
nance, repair, or electrical wiring.
A. Introduction
The HEAT-OUT-GAS PowerFlow Heat Management
system is designed to remove unwanted heat from your
home. The HEAT-OUT-GAS operates on 120VAC, 60Hz
electrical services.
B. Approvals
The HEAT-OUT-GAS kit uses fl exible duct marked as meet-
ing requirements of UL-181, Class I ducting.
For use with all Models equipped with IntelliFire™ Touch.