5
1-800-221-2099 • HearingHelp.com
If the pre-cut tubing that is attached to your Ranger hearing aid
is too short or too long, follow the directions below using the
full-length elbow joint tubing enclosed.
HOW
TO
MEASURE
AND
ATTACH
THE
FULL
-
LENGTH
TUBING
HOW
TO
ATTACH
/
REMOVE
THE
EARTIP
ATTACHING THE EARTIP: Push the flat end of the
silicone eartip securely onto the firm, plastic elbow
joint at the end of the tubing.
REMOVING THE EARTIP: Hold the eartip between two
fingers and grasp the elbow area of the tubing and pull
the two parts away from each other.
Attention: Make sure eartips are securely attached to the tubing before using so they do not come off in your ear.
The fit of your hearing aid is very important. Try the different sizes of
eartips until you find one that is secure and comfortable.
1
2
3
Put eartip and Ranger in place.
Place the eartip with attached tubing in your ear
and the hearing aid over your ear.
CUT OFF EXTRA TUBING
Observe where the tubing overlaps the earhook
and mark the tubing leaving an
1⁄8
to
¼
inch
overlap.
Cut off extra tubing
.
Attach tubing to earhook.
Insert the tip of the earhook into the tubing. If it is
hard to insert, warm the tip of the flexible tubing
with hot water.
