Operating Your Inhaler
Follow the cleaning instructions in this
guidebook under ‘Cleaning Technique’ prior to
using your Steam Inhaler for the first time or
after it has been stored for an extended
period of time .
REMEMBER:
Always unplug the Inhaler and
make sure the POWER switch is turned to the
‘OFF’ position before cleaning, assembling and
before or after each use .
1) Place the Inhaler
on a flat, stable
surface within reach,
with the mask facing
towards you,
Fig. 3
.
2) Gently pull straight up
on the cover of the
Inhaler to remove lid .
3) Remove the cap to the
water heater tank by
turning it
counterclockwise,
Fig. 4
.
4) Using the included
measuring cup, fill the
water heater tank with
approximately 25 mL of
tap water,
Fig. 5
. Do not
fill water above the five
square-shaped vents on
the wall of the tank .
NOTE:
Do not use any-
thing except water in
the water heater tank .
5) Reattach the cap and
the cover .
6) If desired, remove
the aromatherapy/drain
tank from the unit . Fill
the aromatherapy tank
with up to 60 mL of
saline or aromatherapy
water,
Fig. 6
.
7) Return the
aromatherapy/drain
tank to the unit
making sure that the
suction tube makes
contact with the
bottom of the tank .
Cleaning Procedures
Rinsing Technique
(Performed after each use):
1) Make sure that the unit has cooled (approx.
10 minutes), the POWER switch has been
turned to the ‘OFF’ position and the unit has
been disconnected from the power source.
2) Remove the cover
from the body of the
Steam Inhaler . Remove
the cap to the water
heater tank,
Fig. 1
.
3) Carefully remove the
one-piece
aromatherapy/drain tank
from the unit,
Fig. 2
.
4) Rinse aromatherapy/
drain tank with hot tap
water .
5) Empty any remaining
water from the water
heater tank .
6) Dry with clean towels or
allow to completely air
dry .
7) Reassemble the Steam Inhaler and store in a
cool, dry place .
Cleaning Technique
(Performed once a week or before first time
use):
1) Follow steps 1-5 under ‘Rinsing Technique .’
2) Wash aromatherapy/drain tank, cover, water
heater tank cover, extension tube and mask
in warm water and a mild detergent .
Thoroughly rinse and allow to completely
dry .
Cleaning the Steam Inhaler
NEVER submerge the main unit in water.
Wipe the Steam Inhaler using a soft, slightly
water-moistened cloth .
NOTE:
Any other form of cleaning or
cleaning agents may damage the unit and void
your warranty .
4
Fig. 1
Fig. 4
Fig. 2
Fig. 6
Fig. 5
Fig. 3
