7
7. Attach the Seat (14) to the Seat Frame (13) with four
1/4” x 19mm Screws (59) and four M6 Washers (56).
59
56
14
13
7
6. Attach the front of the Seat Frame (13) to the Seat
Carriage (12) with two M8 x 40mm Carriage Bolts (57)
and two M8 Nylon Jamnuts (82). Do not tighten the
Nylon Jamnuts yet.
Attach the back of the Seat Frame (13) to the Seat
Carriage (12) with two M8 x 36mm Button Bolts (81)
and two M8 Nylon Jamnuts (82). Note: The Button
Bolts must be inserted from below to provide maxi-
mum clearance around the Seat Knob (34).
Tighten all four M8 Nylon Jamnuts (82).
13
82
81
57
82
82
12
34
6
5. The Console (4) requires four “D” batteries (not includ-
ed); alkaline batteries are recommended. Refer to the
inset drawing. Press the tab on the battery cover, and
lift off the battery cover. Insert four batteries into the
battery compartment. Make sure that the batteries
are oriented as shown by the diagram inside the
battery compartment. Reattach the battery cover.
While another person holds the Console (4), connect
the wire harness on the Console to the Upper Wire
Harness (39). Insert the wire harnesses down into the
Upright (2). Attach the Console to the Upright with
three M10 x 27mm Patch Screws (51). Be careful to
avoid pinching the wire harnesses.
Slide the Console Collar (6) to the top of the Upright
(2). Attach the Console Collar with two M5 x 16mm
Screws (62).
4
39
51
51
2
6
Wire
Harness
62
4
Tab
Batteries
Battery
Cover
5
