10
8. Insert the ground wires into the console assem-
bly as you set the console assembly on the Left
Upright (75) and the Right Upright (not shown).
Make sure that no wires are pinched.
Attach the console assembly with eight #8 x 3/4"
Screws (6) (four are shown);
start all eight
Screws, and then tighten each of them. Do
not overtighten the Screws.
Insert the wires into the Left Upright (75).
Fully tighten the ten Bolts (7, 9, and 10) (only
one side is shown).
See step 3.
Fully tighten the six 3/8" x 4" Patch
Bolts (4).
6
8
Console
Assembly
9
7
6
10
75
Wires
Console
Assembly
Wire
Tie
70
7
70
75
Console
Wire
7. Locate the tie in the console assembly. Use the
tie to pull the ground wires out of the hole in the
console assembly.
With the help of a second person, hold the con-
sole assembly near the Left Upright (75).
Connect the Upright Wire (70) to the console
wire.
See the inset drawing. The connectors
should slide together easily and snap into
place.
If they do not, turn one connector and try
again.
IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Remove the wire tie from the Upright Wire (70).
Connect the ground wires and remove the tie.
Console
Wire
Ground
Wires
Tie
Ground
Wires
