P/N 82-00003 PROPLUSROD INSTALLATION INSTRUCTIONS REV20190801
5.
Position Height Rod in front of the Upper and
Lower HR Mount Brackets so that the 2 holes
in the Upper HR Mount Bracket are positioned
over the 2 threaded holes on the back of the
HR assembly. Thread 2 each ¼”-20 x 5/16”
Button Head Screws into the threaded holes
on the rear of the Height Rod Assembly.
Tighten top and bottom Screws with 5/32”
Wrench.
6.
Position Height Rod in front of the Upper and
Lower HR Mount Brackets so that the 2 holes
in the Lower HR Mount Bracket are positioned
over the 2 threaded holes on the back of the
HR assembly. Thread 2 each ¼”-20 x 5/16”
Button Head Screws into the threaded holes
on the rear of the Height Rod Assembly.
Tighten both Screws with 5/32” Wrench.
7.
Using the 8mm Allen Wrench, fully tighten and
secure the Upper and Lower HR Mount
Brackets by tightening the M10 x 1.5 x 45mm
Button Head Screws. Assembly is now
complete.
