Health O Meter 2500KL, Инструкция пользователя

Страница: 19 / 28

19
SETUP / BATTERIES
Opening the 2600KL Scale
1. From its upright folded position, gently lower the scale onto its feet. Use the scale
handles, located on the front of the platform (see Figure 10).
2. Loosen all four of the handrail locking pin assemblies by turning the locking pins
counterclockwise (see Figure 8).
Note: The assemblies are spring loaded, and will pop out when completely loosened.
3. Grasp the center handrail near the display assembly, and lift the handrail to an upright
position.
4. Lock the center handrail in the upright position by tightening the two upper handrail
locking pin assemblies. In addition, to avoid damage to the pin assemblies, tighten the two
lower locking pin assemblies as well.
Preparing the 2500KL / 2600KL Scale for Use
1. Remove the protective plastic film covering the display (the film says “FACTORY
CALIBRATED”).
2. Place batteries into the battery holder (see “Replacing / Inserting Batteries” information
below).
3. Connect the AC adapter into the adaptor jack on the display assembly.
4. Plug the scale’s AC adapter into the power source.
5. Ensure all objects are removed from the scale’s platform. Press the ON/OFF button to
turn the scale on. The display will show “Start”, then “0.0LB” or “0.0KG”.
6. Press the UNIT button to select the weight mode (lb or kg).
Note: These scales will always default to the settings and units last used (lb or kg).
7. When you disconnect the scale’s AC adapter from the power source, the scale will switch
to battery power if batteries are installed.
Note: If the setup procedure failed, refer to the troubleshooting instructions. If the problem is
not corrected, refer to qualified service personnel.